Short Implants Produced by Additive Manufacturing in the Posterior Jaws: 3 Years of Follow-up

Enrolling by invitation

Conditions studied: Periodontal Diseases, Dental Implant Failed

In brief

Implant-supported rehabilitation of regions with severe bone resorption is a challenge for implant dentists. Structures such as the maxillary sinus and the inferior alveolar canal often make it impossible to use implants of lengths considered standard in the literature. The use of short implants produced by additive manufacturing (AM) provides a new surface, promoting osseointegration and reducing problems such as peri-implantitis. However, longitudinal evaluations of implants produced by AM are still scarce in the literature. A total of 100 subjects rehabilitated with short implants produced by MA, with diameters between 4.0 to 6.0 mm and 5 to 7 mm in length, will be evaluated. Peri-implant bone remodeling, as well as clinical parameters, will be evaluated by implant and throughout the evaluation time. Periapical radiographs will be obtained and scanned, analyzed by software, and compared to baseline data. The data obtained will be analyzed, allowing longitudinal evaluations and the success rate of implant restorations supported by short implants.

Key facts

Study ID
NCT07688421
Run by
University of Guarulhos
People needed
100
Starts
2026-06-28
Expected to finish
2027-02-28
Last updated by the study team
2026-07-17

Who can join

Age: 18 and older. Sex: any. Healthy volunteers: not accepted.

You may qualify if…

You may not qualify if…

Where it is running

Full record on ClinicalTrials.gov

Trial information comes from ClinicalTrials.gov and is refreshed daily. TrialsForMe does not provide medical care and does not run the studies it lists.