Utilization of a 3D Printed Mechanical Balancer During Total Knee Arthroplasty (TKA)

Starting soon · Not applicable

Conditions studied: Total Knee Arthroplasty

In brief

The aim of this study is to test a 3D-printed mechanical balancer in a clinical setting during surgery to further evaluate the utility of the device. This will be a pilot prospective study of 50 patients undergoing primary total knee arthroplasty. Surgeons will utilize the device intraoperatively in addition to the standard of care practices of mechanical balancing. It will not guide clinical decision making.

Key facts

Study ID

NCT06654661

Run by

NYU Langone Health

People needed

50

Starts

2026-06-01

Expected to finish

2027-06-01

Last updated by the study team

2026-03-04

Who can join

Age: 18 and older. Sex: any. Healthy volunteers: not accepted.

You may qualify if…

• Surgical candidates undergoing primary TKA

You may not qualify if…

• Patient is unable to provide written consent

Where it is running

• NYU Langone Health — New York, New York, United States

Full record on ClinicalTrials.gov

Trial information comes from ClinicalTrials.gov and is refreshed daily. TrialsForMe does not provide medical care and does not run the studies it lists.