Evaluation of Bone Gain Using Customized 3D Zirconia Barrier Versus Titanium Mesh

Recruiting now · Not applicable

Conditions studied: Bone Loss, Alveolar

In brief

Evaluation of clinical and radiographical amount of bone gained using customized 3D printed zirconia barrier compared to titanium mesh in combined ridge defect at the esthetic zone.

Key facts

Study ID

NCT06559605

Run by

Cairo University

People needed

26

Starts

2024-05-22

Expected to finish

2026-11-22

Last updated by the study team

2024-08-20

Who can join

Age: 20 and older, up to 70. Sex: any. Healthy volunteers: accepted.

You may qualify if…

• Age: 20-70 years.
• Bone width less than 4mm
• Vertical bone height less than 9mm
• Periodontally sound neighboring teeth
• Patients with sound vertical occlusal bite dimension
• Good oral hygiene (full mouth plaque control record [PCR] < 25%,full mouth bleeding on probing (BOP) < 25% .
• Patients demonstrating understanding and commitment to the post-operative care regime and the study follow up timeline.
• Good general health (including participants with well-controlled systemic disease)

You may not qualify if…

• Pathological lesions (abscess-cyst-acute infection) in the defect site
• Systemic diseases that would interfere with bone metabolism
• Uncontrolled diabetic patients
• Ongoing treatment or a history of recent chemotherapy or radiotherapy
• Poor oral hygiene after hygienic phase (Plaque control record over 30%) or Active periodontal disease

Where it is running

• Cairo university — Cairo, Egypt (enrolling)

Full record on ClinicalTrials.gov

Trial information comes from ClinicalTrials.gov and is refreshed daily. TrialsForMe does not provide medical care and does not run the studies it lists.