The Clinical Study of 3D-printed Magnesium Alloy Prosthesis With Controllable Degradation Rate in the Repair of Periarticular Bone Defects

Recruiting now · Not applicable

Conditions studied: Degradation of Magnesium Alloy Prosthesis and New Bone Regeneration

In brief

Perimarticular fracture bone defect is a common and complicated clinical disease. The current treatment for this type of injury is anatomical reduction of the fracture, where the bone defect is filled with artificial, autologous or allogeneic bone in granular form, and then fixed with plates and screws. However, these bone filler materials exist in a loose accumulation state and cannot form an effective overall support force for the joint. The applicant realized three dimensional (3D) printing of WE43 magnesium alloy with personalized design and porous overall structure, and developed high-temperature heat treatment technology to slow its degradation, which effectively realized the dual stability of degradation rate of magnesium alloy support body and overall structure during the bone repair period. This project will optimize the design of 3D printed WE43 magnesium alloy full-structure in-bone support, and establish a metamaterial pore structure design platform that regulates the physical properties and degradation behavior of porous implants. Fracture from proximal humerus, distal radius and tibial plateau

Key facts

Study ID
NCT06349629
Run by
Peking University Third Hospital
People needed
60
Starts
2023-01-01
Expected to finish
2027-01-01
Last updated by the study team
2024-04-05

Who can join

Age: 18 and older, up to 80. Sex: any. Healthy volunteers: accepted.

You may qualify if…

You may not qualify if…

Where it is running

Full record on ClinicalTrials.gov

Trial information comes from ClinicalTrials.gov and is refreshed daily. TrialsForMe does not provide medical care and does not run the studies it lists.