Fabrication of a Definitive Cad/Cam Titanium Abutment Prior to Guided Surgery: a Pilot Study.

Completed · Not applicable

Conditions studied: Single Edentulous Space

In brief

The study will involve placing a dental implant through a guided surgery protocol developed using 3D CT technology. Because the implant position is planned digitally using the CT data from the patient, this allows investigation of an abutment that supports the implant crown and soft tissues to be fabricated prior to implant placement. In doing so, this makes the protocol for patient care simpler and faster. In fabricating the the abutment prior to surgery, the investigators will design the abutments at different heights below the gumline to see an optimal margin height for fabrication of the abutment prior to surgery. The study hypothesis is that more often the abutment margin placed just slightly below (.5mm) the gumline will be visible about half of the time while the abutment margin placed further under the gumline (1.5mm) will be visible only about 10% of the time. The optimal outcome is that at delivery and follow-up, the abutment margin will not show intraorally.

Key facts

Study ID
NCT02218541
Run by
University of North Carolina, Chapel Hill
People needed
22
Starts
2014-10-01
Expected to finish
2017-05-01
Last updated by the study team
2018-07-27

Who can join

Age: 18 and older, up to 99. Sex: any. Healthy volunteers: accepted.

You may qualify if…

You may not qualify if…

Where it is running

Full record on ClinicalTrials.gov

Trial information comes from ClinicalTrials.gov and is refreshed daily. TrialsForMe does not provide medical care and does not run the studies it lists.